Services

.355 Taper Tip shafts are butt cut only shafts.   Service is for cutting one shaft; for 8 shafts add 8 to cart; etc.   Normally, shafts are installed before butt cutting the shaft, to playing length, so that they include the bottom of hosel...

We recommend prepping tips at time of installation. Service is for cutting one shaft; for 8 shafts add 8 to cart; etc. The longer a tip has been prepped before installation the more likely it will be contaminated; steel oxidation does start immediately...

Most .370 parallel tip shafts are all the same length and need to be tipped differently for each iron.Note:  Some .370 tip shaft models that are discrete lengths(pre-tipped by manufacurer); check the spec charts. Service is for cutting tip of one...

Service is to install a grip you purchase from us. For one grip add one to cart; for 8 grips as 8 to cart; etc. Includes: labor, tools, tape, solvent, supplies, etc.

NOTE:   .370 Parallel Tip shafts need the tip cut different for each iron length; then butt cut to playing length. Service is for cutting one shaft; for 8 shafts add 8 to cart; etc. Normally, shafts are installed before butt cutting the shaft,...

To save and reuse a grip, we attempt to remove and re-install. These are often not easy to remove and salvage; we recommend a new grip. Includes: labor, tools, tape, solvent, supplies, etc.

Service is for one grip; for 8 grips add 8 to cart; etc. Includes: labor, tools, tape, solvent, supplies, etc.

All shafts have spines that are caused by manufacturing processes and variations; some are weak and some are stronger. Shaft spines cause a shaft to bend more easily in one direction than in other directions. We recommend aligning shaft spines so that...

Service is to check the loft and lie of a club and adjust to standard specifications or the specifications you provide.

This Service covers the cost to pack and ship a club back to you; after we have performed the Services you have requested. Includes packaging, materials, labor, postage and insurance.

Service includes clean and prep head hosel, prep shaft tip, install shaft and cut to playing length.

Service is for:pulling old shaft from head; clean and prep head hosel bore; prep shaft tip; install Black 3/4" ferrule; epoxy shaft in head, and cut to playing length.If you need playing length different from Standard, add your specifications, in the...